Queen size captains bed – To build queen size captains bed, starting with arranges two 60-inch beams and two 77-inch beams in a rectangle. The ends of longer beams adjoining faces of shorter beams. Screw them into place with three wooden screws per corner. Second, slide a third 77-inch trawl into the center line of the rectangle. Set in the middle and tighten with three wooden screws per end. Repeat steps one and two more, build a total of three frames. Fourth, stable wood frames on top of each other.
Fifth steps to build queen size captains bed is, insert a 36-inch 60-inch plywood sheet against a short end of stacked frames. Screw it to the frames with three parallel lines with six wooden screws each. For each line, run two screws in each of the beams at the rear. Put a line of screws on the center, the other one inch from one of the edges. Repeat step five to attach the other 60-inch plywood sheet to the opposite short edge. Seventh, insert a 36-inch 80-inch plywood sheet against a long end of stacked frames.
Screw it in place as you did with the shorter ends. If you cannot find 80-inch long load, use two 40-inch sheets. Repeat step seven to attach the remaining 80-inch plywood sheet to the opposite long end. Lay the two 60-inches with 40-inch plywood sheets on top of the frame. Screw in place with one screw per corner and one screw in the center of each edge. Sand down the corners on top of the queen size captains bed. Apply painter’s kittens to all visible screw heads, and in some dings or divots in your wooden load. Let it dry. Paint all visible faces of wood load.
12 Steps By Steps To Build A Queen Size Captains Bed Photos